User Manual
Table Of Contents
- Introduction:
- Product overview
- Preparing the installation
- Executing the installation
- Configuring the installation
- Integrating the installation with other systems
- Servicing the installation
- Troubleshooting
- Regulatory information
- About Nedap
- Blank Page
Page of 14 43 Manual FC-line
Field distribution for RF
There are two modes of operation for RF technology. The mode can be configured during the configuration
wizard.
There is an RF field in between gates. This mode is preferred for the best performance of theFocused field.
system.
There is an RF field around the gate. This mode is mainly used when the gates are placed near theFull field.
checkouts, as you can have one gate covering a relatively large area.
Infra-read beam sensors
Please note that when you want to use infrared beam sensors for customer counting, you can only
count customers in between the gates. So, if you set RF to full field, you are not able to count
customers outside of the gates.