User Manual
Table Of Contents
- Introduction:
- Product overview
- Preparing the installation
- Executing the installation
- Configuring the installation
- Integrating the installation with other systems
- Servicing the installation
- Troubleshooting
- Regulatory information
- About Nedap
- Blank Page
Page of 26 43 Manual FC-line
Status LEDs on Renos unit
The electronics inside the unit has several status LEDs that can be used to discover the status of each part of
the electronics.
Led Color Status Explanation
1 Green
On There is a Renos unit connected to the OUT port of this unit
Off
There is Renos unit connected to the OUT port of this unitno
2 Blue
Blinking
There is device connected to the OUT port of this unitno
On There is a Power Inserter connected to the OUT port of this unit
3 Red
On There is an issue with the power supply at the OUT port of this unit (too little current drawn)
Blinking There is an issue with the power supply at the OUT port of this unit (too much current drawn)
Off
There is issue with the power supply at the OUT port of this unitno
4 Yellow
Blinking The operating system on the Renos unit is running
Off
The operating system on the Renos unit is runningnot
5 Green
Blinking The storage flash on the Renos unit is accessed
Off
The storage flash on the Renos unit is accessednot
6 Green
On The firmware on the Renos unit is running
Off
The firmware on the Renos unit is (yet) runningnot
Please refer to the Troubleshooting chapter later in this manual to resolve erroneous conditions.