User's Manual
Table Of Contents
- Introduction
- Product overview
- Preparing the installation
- Executing the installation
- Configuring the installation
- Integrating the installation with other systems
- Servicing the installation
- Troubleshooting
- Regulatory information
- About Nedap
Page of 39 55 Manual FLR-line
Led Color Status Explanation
Off
The RFID reader is connected to the Renos firmwarenot
2 Orange
Blinking slow The firmware on the RFID Reader is running
Off
The firmware on the RFID reader is runningnot
3 Red
On There is an error with the RFID output
Off
There is error with the RFID outputno
4 Green
On The RFID output is active
Blinking The reader is reading RFID labels
Off
The RFID output is activenot
5 Green
On The RFID reader is powered by the Renos unit
Off
The RFID reader is powered by the Renos unitnot
Status of LEDs before configuration
When the system is not configured yet, the RFID reader will not be active. This means that only the
'firmware running' orange LED is blinking.