User Manual

Invexs 170 readers
© Nedap N.V. Invexs 170 readers Installation sheet
Page 2 of 4
R
GND
UL*/NA* / BEEP
CONNECTIONS
Invexs is not hot-swappable, so when making or changing connections power must be switched Off.
Remark:
Cable shield must be connected to Power GND of Convexs (A2) and GND of external device
(or metal case).
If connected to a 120kHz RF device (AEOS Nedap reader AEpack or XS device) the power is
supplied via the Convexs adapters (AX1014 for AEpacks, AB350 for XS devices). Existing
antenna cabling can then be reused for connecting the ConveXS.
UL*,NA* and BEEP are Open Collector to GND.
If the Convexs adapters are used, the original UL and NA signals are
converted to the UL* and NA*.
LED INDICATORS INSIDE
There are two LED’s available: Blue for Status (of application), Green for Identification (both visible
through two small holes at the back side)
LED INDICATORS FRONT
At the front a three colour LED is positioned at the middle of the Invexs
Depending of the used configuration the function of these LED’s can differ:
Green LED: Card is been authorised (UL led)
Red LED: Card is not authorised (NA led), controller is stand-by
Blue LED:
Blinks fast: No configuration is availabele at this Invexs (present Configuration
card or load Configuration first).
Continuously ON: Determined by configuration: E.g. Reader stand-by.
(Blue LED is activated if UL is OFF and NA is more than 1 sec OFF)
Remark:
Function of LED’s and Beeper is controlled by used application settings of Invexs. Green and Red
LED can be controlled by hardware signals (Connector 8 and 10) or RS485NR, Blue LED
indirectly by UL and NA, if this setting is activated (configuration).
Beeper can be controlled by hardware signal (Connector 7), RS485NR or software (configuration).
Invexs
Function
1
Power /
XSMOD
Power in (10-30VDC) /
XS modulator (120kHz)
2
POWER GND/Shield
Power Ground
3
A (-)
RS485
4
B (+)
RS485
5
D0
Wiegand Data 0
6
D1
Wiegand Data 1
7
BEEP
Beep input
8
UL*
UL led input
9
GND
Led Common Ground
10
NA*
NA led input
1
10
1
10
5
1
6
1
Invexs with display
Invexs without display
ID (green)
Blinking
Card detected
ST: STATUS (blue)
Slow blinking
Application running (operating)
Fast blinking
Downloading or error during loading
2 short flashes
Application present but not active
3 short flashes
No application present