Installation Manual for the application example: Luxon Wireless 2450 June 2011 Page 1 of 7
1. Brief product description The Luxon Wireless 2450 can be added to the Luxon e-HID ballast or fixture. It regulates the communication between the ballast/fixture and the Luxon Light Controller (LLC). After installation the Luxon Wireless 2450 becomes a RF node in the network, and data can be send wirelessly to the light controller. Luxon wireless 2450 Figure 1.
2.
Figure 2d: Luxon Wireless 2450 mechanically secured to the front plate by screws Figure 2e: Luxon Wireless 2450 wired to the Luxon e-HID ballast Figure 2f: Detailled photograph of the connectors Figure 2g: Frontview of the Luxon e-HID ballast Page 4 of 7
3. Positioning The Luxon Wireless 2450 will be mounted to a cover of a Luxon e-HID ballast or fixture Note: 1) This transmitter should only be used or installed at locations where there is at least 20cm separation distance between the antenna and all persons. This is to comply with FCC RF exposure requirements for mobile transmitting devices. 2) The Luxon Wireless 2450 shall never be installed inside a metal power cabinet. This would impede wireless communication.
7. FCC and IC Declarations for Luxon Wireless 2450 This device contains Luxon Wireless 2450 with FCC ID: CGDLW2450 and IC: 1444A-LW2450 Compliance statement This device complies with part 15 of the FCC Rules and to RSS210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
9. Label location Luxon e-HID ballast. Attach the label to the Luxon e-HID ballast as shown in the following figure 5. Fig. 5.
