User's Manual

Page 6 of 9
2 System overview
Figure 1 Functional system overview
The system consists of the following components:
1. X2 Rx/Tx Unit
2. NCC unit for communication
3. Power inserter
4. Antenna frame 27 cm Model: PG27
5. Antenna frame 39 cm Model: PG39
6. Antenna frame 30 cm Model: FL30
7. Antenna frame 45 cm Model: FL45
8. Antenna frame 37 cm Model: W37-CC
9. Antenna frame 45 cm Model: EQ45-F Floor antenna
10. Customer Counting unit including Lighting
11. Optional communication units:
• PSTN: MT5600SMI-92 by Multitech CE approved, Canada IC: 125 11142A and USA FCC complies
with 47 CFR Part 68: AU7USA-46014-MD-E or any other CE, FCC and IC approved PSTN.
• GSM/GPRS: MTSMC–G-F4 by Multitech CE approved , Canada IC: 125A-0027 and USA FCC ID:
AU79U07A31817 or any other approved FCC or IC approved GSM
• LAN: XPORT by Lantronix
• WiFi: IEEE 802.11b WiPort 485 by Lantronix FCC ID: R68WIPORTG IC-ID:3867A-WIPORTG
The X2 system is complete wired up and ready for use. You only have to follow up the next steps:
• Install the X2 system according the X2 Electronics Manual;
• Distance between an antenna and a wall, door, sliding door etc. must be at least 0.2 m;
• Distance between an antenna and the nearest tagged item must be at least 2 m;
• Reading range totally (split up in two antenna sides) when using:
o hard tags Ø50 mm and FL30 antennas is: 1.80 m;
o paper tags 40x40 mm and FL30 antennas is: 1.40 m;
o hard tags Ø50 mm and FL45 antennas is: 2.30 m;
o paper tags 40x40 mm and FL45 antennas is: 1.80 m;
o hard tags Ø50 mm and PG27 antennas is: 2.00 m;
o paper tags 40x40 mm and PG27 antennas is: 1.50 m
o hard tags Ø50 mm and PG39 antennas is: 2.60 m;
o paper tags 40x40 mm and PG39 antennas is: 2.00 m;
o hard tags Ø50 mm and W37-CC antennas is: 2.60 m;
o paper tags 40x40 mm and W37-CC antennas is: 2.00 m;
o hard tags Ø50 mm and EQ45-F antennas is: 1.00 m;