User's Manual

Page 7 of 9
o paper tags 40x40 mm and EQ45-F antennas is: 0.75 m;
• Power up the X2 system
• Check the functionality;
• Call Nedap Customer Support for quick hands-on problem solution in case of unforeseen problems
[see Technical Support];
3 Wiring diagram
Schematically diagrams below shows an example of the connections between used modules.
The picture shows the full configuration that can be built up.
Ant. Ant. Ant. Ant. Ant.
Ant.
Figure 2 Example full configuration
The connections for a full configuration are:
1. Datacom cable for NCC to Unit X2
Connects Data communication and power from NCC [9203508] to a Unit X2 RX/TX [9938176]
2. Datacom cable between Unit X2 to second Unit X2
Connects the data and power between the X2 RX/TX Units.
3. Coax cable
Connects the antenna Match PCBA to X2 RX/TX unit [9938176] for the EAS antennas PG27, PG39, FL30,
FL45, W37-CC and EQ45-F
4. Cable for Cusomer counting and lighting unit PG27/PG39
Connects the X2 RX/TX [9938176] to the Customer Counter and lighting unit [7833342]
5. Cable for Cusomer counting and lighting unit W37-CC
Connects the X2 RX/TX [9938176] to the Customer Counter and lighting unit [7835361]
6. Cable for Cusomer counting and lighting unit FL30/FL45
Connects the X2 RX/TX [9938176] to one of the Customer counter units [9923373, 9928529, 9936114,
9935207]
7. Cable for lighting module FL30/FL45
Connects the X2 RX/TX [9938176] to the lighting module
8. DC cable from Power adapter to NCC electronics
Connects the Power-adapter [9651543] to the NCC main board [7824785] and carries 33V DC power
9. Mains cable
Connects the Mains power to the Power-adapter [9651543]
10. Coax cable for GSM antenna
Connects the GSM module to the GSM external antenna to contact the GSM network.
11. Datacom cables to slave NCC’s
Connects a NCC with the behavior “Master” to NCC devices with the behavior “Slave”
12. Datacom cables for system expansion
Connects more antenna strings up to 16 devices with the same function as Wire 1 and 2