Operation Manual

en Appliance door
24
Removing and installing the door panels
For cleaning, you can remove the glass panels from the
appliance door.
To do this, the appliance door must be removed
beforehand (see section "Removing and fitting the
appliance door").
:Warning – Risk of injury!
The appliance must not be used again until the door
panels and appliance door have been correctly fitted.
Removing
Note: Lay the removed glass panels on an even, soft
and clean surface.
1. Remove the appliance door.
2. Lay the appliance door with the front side facing
down on an even, soft and clean surface.
3. Push on the left- and right-hand side on the outside
of the appliance door until the inner glass panel is
released on both sides (Fig. !).
4. Carefully lift the inner glass panel and remove it in
the direction of the arrow (Fig. ").
5. Hold reflector ‚ in area ƒ on the left- and right-hand
side, and carefully lift it upwards (Fig. #).
6. Lift reflector ‚ up and out (Fig. $).
7. Remove the second reflector in the same way as the
first.
8. Push the intermediate glass panel downwards in
area „, carefully lift holder … until it can be pulled out
(Fig. %).
9. Lift the intermediate glass panel from below (Fig. &)
and remove it in the direction of the arrow.
10. Clean the glass door panels and reflectors on both
sides with glass cleaner and a soft cloth.
:Warning
Risk of injury!
Scratched glass in the appliance door may crack.
Do not use a glass scraper or sharp or abrasive
cleaning aids or detergents.
Caution!
Damage to the lighting. Do not clean or touch LED ‚
in the appliance door.
11. Dry and refit the glass door panels.
2
1

D

D
E

F
G

D