Installation Instruction

Table Of Contents
en Appliance door
28
18.3 Removing the door panes
To facilitate cleaning, you can remove the door pane.
WARNING‒Risk of injury!
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
Requirement:The appliance door is detached.
1.
Lay the appliance door with the front side facing
down on a flat surface that is soft and clean.
2.
Push on the left- and right-hand side of the appli-
ance door from the outside until the inner pane is
released on both sides.
3.
Carefully lift the inner pane and remove it in the dir-
ection of the arrow ⁠.
4.
Push down on the intermediate pane lightly in the
area of , and carefully lift the retainer until you
are able to pull it out.
5.
Lift the first and second intermediate panes from be-
low and remove them in the direction of the arrow
⁠.
6.
Remove the spacers and seals for cleaning, if
required.
7.
WARNING‒Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or
sharp metal scrapers to clean the glass on the
oven door, as they may scratch the surface.
Clean the door panes on both sides with glass
cleaner and a soft cloth.
8.
Dry the door panes and refit them.
18.4 Fitting the door panes
WARNING‒Risk of injury!
If a door pane or appliance door has not been installed
correctly, this is dangerous.
Make sure that all of the door panes and the appli-
ance door have been correctly fitted before you
switch the appliance back on again.
1.
Tip:When fitting the door panes, make sure that
they are in the original order.
Insert the intermediate pane so that the arrow on
the right-hand side is pointing upwards.