User Manual
en Appliance door
34
Fitting
Note: When fitting the glass door panels, ensure that
they are in the original order.
1. Insert the intermediate glass panel so that arrow ‚ is
pointing towards the upper right-hand corner
(Fig. !).
2. Check the fit of the four spacers and two seals on
the intermediate glass panel:
– Place the spacers centrally over each marker line
(Fig. ").
– Secure the seals at the corners (Fig. #).
3. Insert the intermediate glass panel using seals and
spacers. The arrow on the intermediate glass panel
must line up with the arrow on the frame (Fig. $).
4. Insert the second intermediate glass panel without
using seals and spacers and push it in the direction
of the arrow until it is fitted in the frame. The arrow
on the intermediate glass panel must line up with the
arrow on the frame (Fig. %).
5. Push the intermediate glass panel downwards in
area ƒ, insert holder „ at an angle and push down
until it locks into place (Fig. &).
The holder is inserted (Fig. ').
Caution!
Do not touch the glass rod with bare fingers. Fatty
deposits decrease the effect of light transfer. Clean
the glass rod with glass cleaner once it has been
inserted.
6. Select the left-hand reflector (Fig. ().
7. Insert left-hand reflector … at the top (Fig. )).
8. Insert reflector … (Fig. *).
9. Fit reflector … into slot † (Fig. +).
10. Insert the second
reflector on the right-hand side in the same way as
the left-hand reflector.
11. If necessary, use glass cleaner to remove any finger
marks from the reflectors.
12. Insert the inner glass panel into mounting rail ‡ at an
angle towards the back (Fig. ,).
13. Push down on the inner glass panel until it locks into
place (Fig. -).
1
D
2
F
E
G
G
H
G
G
H
I