Operation Manual

13
Basic settings
Your appliance has various basic settings, which are preset at
the factory. You can, however, change these basic settings as
required.
If you want to cancel all the changes, you can restore the
factory settings.
1. Press the ~ main switch to turn on the appliance.
2. Press and hold the o button for 3 seconds to go to the basic
settings menu.
™‚ appears in the display.
3. Press the o button repeatedly until the current basic setting
for the corresponding sub menu is displayed.
4. Turn the rotary selector to change the basic setting.
5. Press and hold the o button for 3 seconds to exit the basic
settings menu.
The change is saved.
You can change the following basic settings:
Care and cleaning
In this section, you will find information on
the care and cleaning of your appliance
Descaling
: Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of surface damage: Do not use
harsh or abrasive cleaning agents
oven cleaners
corrosive or aggressive cleaners, or those containing
chlorine
cleaning agents with a high alcohol content
If such an agent comes into contact with the front of the
appliance, wash it off immediately with water.
Caution!
Risk of surface damage: If descaler comes into contact with the
front of the appliance or any other sensitive surfaces, wash it off
immediately with water.
Remove food residues from the cooking compartment as soon
as the appliance has cooled.
Salts are very corrosive and can cause rust. Remove remains
of acidic sauces (ketchup, mustard) or salted food from the
cooking compartment immediately after cooling.
Do not use hard scouring pads or cleaning sponges.
Basic setting menu
Submenu Basic setting Setting
symbol
Audible signal when
button is pressed
Audible signal off
™‚
Audible signal on
™‚
Audible signal when
operation ends
Short audible signal (30 sec-
onds)
™ƒ
Medium audible signal (2
minutes)
™ƒ ƒ
Long audible signal (10 min-
utes)
™ƒ
Auto start: not neces-
sary to restart after
opening the appli-
ance door
Auto start off
™„
Auto start on
™„
Water hardness
range for the descal-
ing indicator
softened
™…
soft (I)
™…
medium (II)
™… ƒ
hard (III)
™…
very hard (IV)
™…
Audible signal for
end of heating up
Auto start off
™†
Auto start on
™†
Adjust the cooking
results in the pro-
grammes individually
Cooked normally
™‡
Less thoroughly cooked
™‡ ƒ
More thoroughly cooked
™‡
Restore the appli-
ance to the factory
setting*
Do not restore
™ˆ
Restore
™ˆ
* Factory setting:
all changes to the basic settings are deleted
automatic calibration is carried out again
The appliance is restored to the factory setting if you select
™ˆ and then press and hold the o button for 4 seconds.