Operation Manual

16
Changing the door seal
If the seal around the outside of the cooking compartment is
faulty, it must be replaced. Replacement seals for your
appliance can be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
1.Open the appliance door.
2.Pull off the old seal.
3.Push in the new door seal at one point and pull it in all the
way round. The joint must be at the side.
4.Check again that the seal is correctly fitted in the corners.
Replacing the cooking compartment bulb
The cooking compartment light in your appliance is a durable
LED light. If a fault does occur in the LED light, contact the after-
sales service. The glass light cover must not be removed
Extremely loud pumping sound during
cooking
Water tank is empty, but water is still evap-
orating in the evaporator dish
Filling the water tank
The water tank has not been inserted
properly
Slide in the water tank until it engages
Pumping sound during cooking This is normal
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam.
This is normal
When you cook with steam, a lot of steam
is created
The appliance is being automatically cali-
brated
This is normal (see section: Automatic cal-
ibration)
When cooking with steam, a lot of steam is
created again
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Restore the appliance to factory settings
(see section: Basic settings) and recali-
brate the appliance (see section: Before
first use)
Steam escapes from the ventilation slots
during cooking
This is normal
The appliance is not producing steam
properly
Limescale has formed in the appliance Start the descaling programme.
Hose for the water inlet in the cooking
compartment was pushed to the side or
has hooked itself to the side of the cook-
ing compartment wall.
Strong pressure on the hose or hooking of
objects when cleaning
Call after-sales service and do not use the
appliance.
Cooking compartment light has failed The LED lamp is defective Contact the after-sales service. The glass
light cover cannot be removed
An
“... error message appears in the dis-
play
Technical fault.
Press the KJ clock function button to
delete the error message, and reset the
clock if necessary.
If the error message appears again, call
the after-sales service
The error message
“‹‚‚ appears in the
display
A button was pressed for too long or is
jammed
Press the
KJ clock function button to
delete the error message
Press all of the buttons individually and
check if they are clean
The appliance is not heating. The colon
flashes in the display
A button combination was activated
Press and hold the
o button for
4 seconds, then press the
Í button
Problem Possible cause Notes/remedy