Operation Manual

8
Before using for the first time
In this section you will find out which steps are required before
using the appliance for the first time:
■ setting the clock
■ changing the water hardness range if required
■ before first use
■ cleaning the accessories before use
Your appliance was thoroughly factory tested for proper
operation. As a result, there may already be a small amount of
condensation in the appliance.
Setting the clock
After connecting the appliance to the mains or after a power
cut, the symbols
KJ and 3 appear. ‹:‹‹ appears in the
display. Make the following settings:
1.Use the clock rotary selector to set the current time.
2.Press the KJ clock function button.
The current time is applied.
Note: If the time of day is not displayed after it is entered, the
clock display is switched off. To switch on the clock display,
press the clock function button
KJ until the time of day is
displayed.
Setting the water hardness range
Descale your appliance regularly. This is the only way to
prevent damage.
Your appliance automatically displays when it needs descaling.
It has been preset to water hardness range "medium". Change
the value if your water is softer or harder.
You can check the water hardness with the test strips supplied
or ask your water supplier.
If your water is very hard, we recommend that you use softened
water.
You can only dispense with descaling completely if you
exclusively use softened water. If this is the case, change the
water hardness to "softened".
You can change the water hardness in the basic settings:
1.Press the ~ main switch to turn on the appliance.
2.Press and hold the o button for 3 seconds to go to the basic
settings menu.
™‚ ‚ appears in the display.
3.Briefly press the o button repeatedly until ™… ƒ appears
(water hardness range "medium").
4.Turn the rotary selector to change the water hardness range.
Possible values:
5.Press and hold the o button for 3 seconds to exit the basic
settings menu.
The change is saved.
First use
Before first use, heat the empty appliance for 20 minutes at
100 °C. Do not open the appliance door during this time. The
appliance is automatically calibrated (see section: Automatic
calibration).
1.Press the ~ main switch to turn on the appliance.
2.Fill the water tank and insert it (see section: Filling the
water tank).
3.Press the 100° temperature button.
4.Press the … button.
The appliance heats up to 100 °C. The cooking time
(20 minutes) does not start to count down until the set
temperature has been reached. Do not open the appliance
door during this time.
The cooking operation ends automatically and an audible
signal sounds.
5.Press the ~ main switch to turn off the appliance.
Leave the appliance door ajar until the appliance has cooled
down.
Cleaning the accessories before use
Using soapy water and a soft cloth, clean the accessories
thoroughly before first use.
™… ‹
softened -
™… ‚
soft I
™… ƒ
moderate II
™… „
hard II
™… …
very hard IV