Extractor hood [en] Instruction manual D39L49S0, D36L49S0
Ú Table of contents e[nuoIrs]ctimanul Important safety information.....................................................3 Environmental protection ..........................................................5 Saving energy......................................................................................5 Environmentally-friendly disposal.....................................................5 Operating modes........................................................................5 Exhaust air mode .........
In combination with an activated vapour extractor hood, room air is extracted from the kitchen and neighbouring rooms - a partial vacuum is produced if not enough fresh air is supplied. Toxic gases from the chimney or the extraction shaft are sucked back into the living space. ■ Adequate incoming air must therefore always be ensured. ■ An incoming/exhaust air wall box alone will not ensure compliance with the limit.
Causes of damage Caution! Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage. Always replace faulty bulbs to prevent the remaining bulbs from overloading. Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth. Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only.
Operating the appliance These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. Fan run-on time Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes. 1. First, press the button for the required fan speed 1, 2 or 3. Control panel The fan run-on is possible in any fan speed. 2.
Area Cleaning agents Stainless steel Hot soapy water: Clean with a dish cloth and dry with a soft cloth. Removing metal grease filter 1. Fold the filter cover upwards. Notes ■ Clean stainless steel surfaces in the direction of the grain only. Special stainless steel cleaning products are available from our after-sales service or from specialist retailers. Apply a very thin layer of the cleaning product with a soft cloth.
Trouble shooting Malfunctions often have simple explanations. Please read the following notes before calling the after-sales service. Malfunction table : Risk of electric shock! Problem Possible cause Solution The appliance does not work The plug is not plugged in. Connect the appliance to the electricity supply Power cut Check whether other kitchen appliances are working Faulty fuse Check in the fuse box to make sure that the fuse for the appliance is OK Incorrect repairs are dangerous.
Accessories for circulated air mode (not included in the delivery) Z5135X5 Z5135X4 Z5135X1 9
Constructa-Neff Vertriebs-GmbH Carl-Wery-Straße 34 D-81739 München GERMANY Register your product online www.neff-international.
