Operating Instructions and Installation Instructions

en Operating the appliance
6
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
The following symbols also appear on the display: ”ªª
(metal grease filter) or ’ªª (activated charcoal filter).
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section: Cleaning and maintenance.
The saturation indicator can be reset while it is flashing.
To do this, touch the - symbol.
Switching over the indicator for circulating-air mode
For circulating-air mode, the electronic control must be
switched over accordingly:
■ The extractor hood must be connected and switched
on.
■ Touch and hold the # and 9 symbols at the same
time, until the ’‹– indicator lights up for the
circulating-air mode "Starter Set". Repeatedly
pressing and holding this button combination
causes the ’–‘ indicator to light up for the
"CleanAir" circulating-air module.
■ Repeatedly pressing and holding this button
combination switches the electronic control back
over to ducted operation (”‚– indicator).
Audible signal
Switching on the audible signal
Touch and hold the # and + symbols at the same time
for approximately three seconds when the fan is
switched on. An audible signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Control panel model 2
Setting the fan
Switching on
■ Touch the # symbol.
The fan starts at setting ƒ.
■ Touch + or - to alter the fan speed.
Switching off
Touch the # symbol.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the ˜ symbol. ˜ƒ appears on the display. Touch
the - symbol to switch back to the ˜‚ intensive setting.
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the ˜ symbol.
Automatic mode
Switching on
■ Touch the # symbol.
The fan starts at setting ƒ.
■ Touch the ‘ symbol.
The optimum fan setting ‘‚, ‘ƒ or ‘„ is
automatically set via a sensor.
Switching off
Touch the ‘ or # symbol to switch automatic mode off.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
Automatic mode can run for a maximum of four hours.
Explanation
#
Fan on/off
4
Noise reduction
3
AirFresh function
-
Reduces the fan settings
+ Increases the fan settings
˜
Intensive setting
‘
Automatic function
6
Light on/off/dimming