Operating/installations instructions
Table Of Contents
- [en] Instructions for installation and use
- Ú Table of contents
- [en] Instructions for installation and use
- 8 Intended use
- ( Important safety information
- 7 Environmental protection
- Ç Operating modes
- 1 Operating the appliance
- Operating the appliance
- Note:
- Control panel model 1
- Setting the fan
- Intensive setting
- Fan run-on time
- AirFresh function
- Lighting
- Saturation display
- Audible signal
- Control panel model 2
- Setting the fan
- Intensive setting
- Fan run-on time
- AirFresh function
- Noise reduction function
- Lighting
- Saturation display
- Audible signal
- 2 Cleaning and maintenance
- 3 Trouble shooting
- 4 Customer service
- ( Important safety information
- K General information
- 5 Installation
- Installation
- Preparing the installation
- Installation
- Attaching and aligning the appliance
- 1. First, remove the protective foil from the back of the appliance and, following installation, remove the foil completely.
- 2. When attaching the appliance, ensure that it engages firmly with the brackets. «
- 3. Align the appliance horizontally by turning the brackets. If required, the appliance can be moved to the right or left. ¬
- 4. Firmly tighten the screws for the brackets. When doing so, hold the brackets securely in place. ®
- 5. Firmly tighten the knurled nuts. ¯
- Connecting the pipes
- Attaching the flue duct
Environmental protection en
5
7Environmental protection
Environmental protection
Environmentally-friendly disposal
Dispose of packaging in an environmentally-friendly
manner.
ÇOperating modes
Operating modes
Exhaust air mode
Note: The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
■ Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
■ If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Circulating-air mode
Notes
■ To bind odours in circulating-air mode, you must
install an activated carbon filter. The different options
for operating the appliance in circulating-air mode
can be found in the brochure. Alternatively, ask your
dealer. The required accessories are available from
specialist retailers, from customer service or from
the Online Shop.
■ For appliances with an additional internal filter, only
the CleanAir recirculation module (see Accessories
for circulating-air mode) can be used.
1Operating the appliance
Operating the appliance
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1
Control panel
Setting the fan
Switching on the appliance
■ Press the # button.
The fan starts at setting ƒ.
■ Press the + or - button to change the fan strength.
Switching off
Press the # button.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting „.
The intensive setting ˜‚ is activated. Pressing the +
button again activates the intensive setting ˜ƒ.
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Fan run-on time
Press the - button until – appears.
After approx. ten minutes, the fan switches off
automatically.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning
used electrical and electronic appliances
(waste electrical and electronic equipment -
WEEE). The guideline determines the
framework for the return and recycling of used
appliances as applicable throughout the EU.
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter and conveyed back into the
kitchen.
Explanation
#
Fan on/off
- Reduce the fan settings/fan run-on time/interval ventilation
+ Increase the fan settings/intensive setting 1, 2
A
Light on/off/dimming
IUHVK
YRO