Operation Manual

11
Electrical connection
Electrical data:
Are to be found on the name plate inside the appli-
ance after removal of the lterframe.
Before undertaking any repairs, always
disconnect the extractor hood from the electricity
supply.
Length of the connecting cable: 1.30 m.
This extractor hood corresponds to EC regulations
concerning RF interference suppression.
Installation
This extractor hood is intended to be mounted
onto the kitchen wall.
1. Unhook the lter-holding Grid (see “Removing
and inserting metal self- supporting grease
lters”)
2. Draw a line on the wall from the ceiling to the
lower edge of the hood at the centre of the lo-
cation where the hood is going to be mounted.
3. Use the template or following the picture to
mark the points (A-B-C) on the wall where the
screws will be mounted.












 






Ensure that the minimum distance between the
hob and the extractor hood is maintained – 400 mm
for the electric or gas hob.
4. Drill ø 12 mm holes A and ø 8 mm holes B for
the extractor hood. Drill ø 8 mm holes C for the
chimney brackets (only if you think to install the
chimney).
5. Insert bracket plugs 11a into the holes A and
screw into place.
6. Insert plugs 11 into the holes B and C so that
they are ush with the wall.
7. Fix the brackets 7.2.1 using the 12a screws
supplied (only if you think to install the chim-
ney).
In case of hood installation in recirculation
version with the chimney, the upper bracket
7.2.1 must be xed together with the Air Outlet
Connection Support 7.3
.
Mounting the hood body
8. Adjust the two screws Vr, on brackets 11a, to a
minimum.
9. Hook the hood canopy onto the two brackets
11a.
10. From inside the hood canopy, adjust the screws
Vr to set the Hood Canopy level.
Installation
Note: Take into account any special accessories
that are going to be tted.


11. Tighten the safety screw 11 in holes B.