Extractor hood [en] Instruction manual I90CN48W0, I92CN48W0
Ú Table of contents e[nuoIrs]ctimanul Important safety information.....................................................3 Environmental protection ..........................................................4 Saving energy......................................................................................4 Environmentally-friendly disposal.....................................................4 Operating mode..........................................................................4 Circulating-air mode ....
: Risk of electric shock! ■ A defective appliance may cause electric shock. Never switch on a defective appliance. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service. Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker in the fuse box.
Operating the appliance Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes. Operating buttons Controls Button Explanation 6 Switches the lighting on and off # Switches off the extractor hood/switches on fan setting 1 92 Switches on fan setting 2 Note: The remote control requires AAA/LR03/1.5 V batteries.
Intermittent mode The intermittent function automatically switches on the extractor hood for 10 minutes every hour. After 24 hours, this function switches itself off again. Note: If intensive mode or the run-on function has been activated, the intermittent function will not be available. Switching on Press and hold the K button on the remote control or the 8 3 button on the extractor hood's control panel. 1. Select the power setting. 2.
Saturation display When the metal grease filters or activated charcoal filters are saturated, the corresponding symbol will flash: ■ ■ ■ Metal grease filter: The F indicator and the # button light up Activated charcoal filter: The F indicator and the 8 3 button light up Metal grease filter and activated charcoal filter: The F indicator and the # and 8 3 buttons light up Do not wait any longer to clean the metal grease filters or replace or regenerate the activated charcoal filters. 3.
By hand: Installing the metal mesh grease filter Note: You can use a special grease solvent for stubborn dirt. It can be ordered via the Online Shop. 1. Insert metal grease filter. 2. Fold the metal grease filter up and click it into place. ■ Soak the metal mesh grease filters in a hot soapy solution. 3. Fold the filter cover upwards. ■ Clean the filters with a brush and then rinse them thoroughly. Leave the metal mesh grease filters to drain. Note: Make sure that the filter cover closes properly.
After-sales service Our after-sales service is there for you if your appliance needs to be repaired. We will always find the right solution in order to avoid unnecessary visits from a service technician. Please be aware that a visit by an after-sales engineer will be charged if a problem turns out to be the result of operator error, even during the warranty period. When calling us, please give the product number (E no.) and the production number (FD no.) so that we can provide you with the correct advice.
Constructa-Neff Vertriebs-GmbH Carl-Wery-Straße 34 D-81739 München GERMANY Register your product online www.neff-international.