Home Connect Guide
11 EN
Step 2.1: Connect your extractor hood to
your home network with WPS
Please enter step 2.1 only when prompted to by the app.
The following steps describe operations at the home
appliance itself.
Note:
To connect the extractor hood to your home
network, the hood and the light must be switched
off. You can cancel the process at any time by
pressing
.
1 | Press and hold the
D
symbol on your remote control until
LED 7 on the appliance starts ashing.
2 | Press the + button on your remote control to start automatic
login to your home network.
LED 1 and LED 7 ash on the appliance.
3 | Activate the WPS function on your home network router
within the next 2minutes.
If connection to the home network is successful, LED 3 and
LED 7 ash on the appliance.
The app will get notied once your extractor hood has been
successfully connected to your Wi-Fi network.
4 | Follow the instructions in the app.
Information:
If the connection could not be established within
2 minutes, make sure your extractor hood is within
the range of your Wi-Fi network.
For some appliances the WPS mode is also called
"automatic mode".