User's Manual
Table Of Contents
- Extractor hood
- en
- Table of contents
- 1 Safety
- 2 Avoiding material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Selecting a fan setting
- 7.4 Switching on intensive mode
- 7.5 Switching off intensive mode
- 7.6 Switching on the fan run-on
- 7.7 Switching on automatic mode
- 7.8 Switching off automatic mode
- 7.9 Intermittent ventilation
- 7.10 Sensor control
- 7.11 Setting the sensor control
- 7.12 Setting the saturation indicator
- 7.13 Resetting the saturation indicator
- 7.14 Switching on Ambient Light
- 7.15 Switching on Guided Air
- 7.16 Switching off Guided Air
- 8 Home Connect
- 9 Hob-based hood control
- 10 Cleaning and servicing
- 10.1 Cleaning products
- 10.2 Cleaning the appliance
- 10.3 Cleaning controls
- 10.4 Cleaning the glass panel
- 10.5 Cleaning the drip tray
- 10.6 Removing the grease filter
- 10.7 Cleaning grease filters manually
- 10.8 Cleaning grease filters in the dishwasher
- 10.9 Cleaning the grease filter cartridge
- 10.10 Fitting the grease filters
- 11 Troubleshooting
- 12 Customer Service
- 13 Accessories
- 14 Disposal
- 15 Declaration of Conformity
- 16 Test information
- 17 Installation instructions
en Installation instructions
20
3.
Screw the covering plate in tightly, depending on
the installation situation.
Installing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
The appliance is heavy.
▶ To move the appliance, twopeople are required.
▶ Use only suitable tools and equipment.
Note:To protect the cables, do not remove the trans-
port lock yet.
1.
Lift the appliance by the short sides and align the
front of the appliance with the hob.
2.
Pull the cable connection into the strain relief and
remove the transport lock .
3.
Note:To ensure that the appliance is not yet fully in-
serted into the cut-out, place a slat below the short
side of the appliance in each case.
Insert the appliance into the cut-out in the worktop
from above.
Insert the appliance evenly so that it is not tilted.
4.
Mark the cut-out for the pipework:
‒ Attach the exhaust air hose for the fan box to the
connector.
‒ Slide the fan box into the guide and tighten this
with a screw.
‒ Mark the position of the pipework on the bottom
of the unit.
‒ Undo the screw and remove the fan box again.
5.
Saw out the cut-out for the pipework.
6.
Slide the fan box into the guide, connect the pipe-
work and screw the fan box tightly back in place.
7.
Support the appliance from below and remove the
slats.
8.
Insert the appliance fully in the cut-out.
9.
Align the rails to the bottom and attach to the
side .