User's Manual
Table Of Contents
- Extractor hood
- en
- Table of contents
- 1 Safety
- 2 Avoiding material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Selecting a fan setting
- 7.4 Switching on intensive mode
- 7.5 Switching off intensive mode
- 7.6 Switching on the fan run-on
- 7.7 Switching on automatic mode
- 7.8 Switching off automatic mode
- 7.9 Intermittent ventilation
- 7.10 Sensor control
- 7.11 Setting the sensor control
- 7.12 Setting the saturation indicator
- 7.13 Resetting the saturation indicator
- 7.14 Switching on Ambient Light
- 7.15 Switching on Guided Air
- 7.16 Switching off Guided Air
- 8 Home Connect
- 9 Hob-based hood control
- 10 Cleaning and servicing
- 10.1 Cleaning products
- 10.2 Cleaning the appliance
- 10.3 Cleaning controls
- 10.4 Cleaning the glass panel
- 10.5 Cleaning the drip tray
- 10.6 Removing the grease filter
- 10.7 Cleaning grease filters manually
- 10.8 Cleaning grease filters in the dishwasher
- 10.9 Cleaning the grease filter cartridge
- 10.10 Fitting the grease filters
- 11 Troubleshooting
- 12 Customer Service
- 13 Accessories
- 14 Disposal
- 15 Declaration of Conformity
- 16 Test information
- 17 Installation instructions
Installation instructions en
21
10.
Screw the rails onto the bottom of the unit.
11.
Note:If an appliance with the dimension 90cm is
installed in a unit with a width of 90 cm, skip the
next two installation steps and follow the instructions
in the additional accessory pack.
Screw in the screw from below and tighten the nut.
12.
Align the appliance to the hob and tension it
against the worktop .
13.
Insert the drip tray and snap it into place.
14.
Plug the cables into the fan box.
15.
Carefully insert the glass pane as far as it will go
into the guides.
16.
Connect the appliance to the power supply.
a The glass panel moves downwards and the appli-
ance closes.
17.
Insert the grease filters.
→"Fitting the grease filters", Page12