User Manual

en operation
16
Ice cube tray
Use the ice cube tray to make ice
cubes.
Making ice cubes
Use only drinking water tomake ice
cubes.
1. Fill the ice cube tray with drinking
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
2. To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
1. Press .
a The appliance begins to cool.
a A warning signal sounds, the tem-
perature display (freezer compart-
ment) flashes and lights up
because the freezer compartment
is still too warm.
2. Switch off the warning tone using
.
a goes out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page16
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The housing around the freezer
compartment is temporarily heated
slightly. This prevents condensa-
tion in the area of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press .
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶ Press / (Refrigerator compart-
ment) repeatedly until the temper-
ature display (refrigerator compart-
ment) shows the required temper-
ature.
The recommended temperature in
the refrigerator compartment is
4°C.
→""OK" sticker", Page19
Setting the freezer compartment
temperature
▶ Press / (Freezer compartment) re-
peatedly until the temperature dis-
play (freezer compartment) shows
the required temperature.
The recommended temperature in
the freezer compartment is
−18°C.