User Manual

en Troubleshooting
26
Fault Cause and troubleshooting
The temperature dis-
play (freezer compart-
ment) flashes.
The temperature in the freezer compartment was too
warm.
1. Press .
a The temperature display (freezer compartment)
briefly indicates the warmest temperature reached
in the freezer compartment. The temperature dis-
play (freezer compartment) then indicates the set
temperature again.
2. Press .
a The temperature display (freezer compartment) no
longer flashes.
A warning tone
sounds, the temperat-
ure display (freezer
compartment) flashes
and lights up.
Different causes are possible.
▶ Press .
a The alarm is switched off.
The appliance door is open.
▶ Close the appliance door.
External ventilation openings are covered up.
▶ Remove any obstructions from in front of the ex-
ternal ventilation openings.
Larger quantities of fresh food have been put in.
▶ Do not exceed the max. freezing capacity.
→"Freezing capacity", Page20
The temperature dif-
fers greatly from the
setting.
Different causes are possible.
1.
Switch off the appliance. →Page16
2. Switch the appliance back on after fiveminutes.
→Page16
‒ If the temperature is too warm, check the temper-
ature again after a couple of hours.
‒ If the temperature is too cold, check the temper-
ature again on the following day.
The base of the refri-
gerator compartment
is wet.
The condensation channel or drainage hole are
blocked.
▶ Clean the condensation channel and the drainage
hole. →Page23
The appliance hums,
bubbles, buzzes,
gargles, clicks or
crackles.
Not a fault. A motor is running, e.g. refrigerating unit,
fan. Refrigerant flows through the pipes. The motor,
switches or solenoid valves are switching on or off.
Automatic defrosting is running.
No action required.