Cookbook

Table Of Contents
37
INGREDIENTS:
1 large onion, approx. 150 g
½ tsp ground paprika
2 tbsp flour
200 ml vegetable oil
2 rump steaks, 180 g each
1 tsp vegetable oil
Salt
Pepper, freshly ground
Per serving:
670 kcal, 15 g carbs, 50 g fat,
41 g protein
PREPARATION
1. Peel the onions and cut into thin rings. Mix the paprika
and flour together and toss the onion rings in the
mixture. Shake off the excess flour.
2. Heat the frying pan as indicated.After the acoustic
signal, add the vegetable oil and half of the onion rings to
the frying pan. Fry the onion rings until they are crispy.
Remove from the frying pan and drain on kitchen paper.
Then fry the remaining onion rings in the same way and
place them to one side.
Frying SensorFrying settingSetting 3Cooking.Hob.EnumType.FryingSensorLevel.Level03DurationAfter the signal, fry for approx. 10 minutes0
3. Pour the rest of the oil into a heat-resistant container
and clean the frying pan.
4. Rinse the steaks under cold water and pat dry with
kitchen towel. Heat the frying pan for the steaks as
indicated. After the signal, distribute the cooking oil
evenly in the frying pan. Place the steaks in the frying pan
and fry on both sides. Then season the steaks with salt
and pepper.
Frying SensorFrying settingSetting 4Cooking.Hob.EnumType.FryingSensorLevel.Level04DurationAfter the signal, fry for 12-15 minutes0
5. Scatter the fried onions over the steaks and serve.
Setting procedure:
Crispy fried onions per portion:
With the frying sensor, “low”
After the signal, fry for approx. 10 minutes
Steaks:
With the frying sensor, “med”
Medium: After the signal, fry for approx. 12 minutes
Well done: After the signal, fry for approx. 15 minutes