User Manual

en Before using for the first time
12
Ventilation modes
This appliance can be used in air extraction or air
recirculation mode.
Exhaust air mode
If the exhaust air is conveyed through the external wall,
a telescopic duct should be used.
Air recirculation mode
Note: To bind odours in air recirculation mode, you
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your specialist dealer. The required accessories are
available from specialist retailers, from our after-sales
service or from our online shop.
KBefore using for the first
time
Be f o r e us i ng for the first time Please read the following information before using the
appliance for the first time:
Clean the appliance and all accessory parts thoroughly.
Before you can use your new appliance, you must apply
certain settings.
Initial use
Note: When it is delivered, the appliance is preset to air
recirculation mode.
Possible settings:
■ In air recirculation mode, if ’‚ˆ is displayed, the
value ‹ (factory setting) is set.
■ In air extraction mode, if ’‚ˆ is displayed, the value
‚ is set.
To switch the appliance to air extraction mode, see
~ "Basic settings" on page 23.
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air that is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.