User Manual

Operating the appliance en
15
Switching on the ventilation system
Note: If the
A symbol is not available, insert the metal
grease filter correctly. ~ "Cleaning" on page 33
The A symbol is available. The ventilation system can
be switched on.
1. Touch the A symbol.
The ventilation system will start at fan setting ƒ. The
fan setting that is selected will be shown on the
display panel. The indicator above the fan symbol
will flash.
Notes
– Heat settings cannot be changed while the
ventilation system fan settings are being
configured.
– During a period of a few seconds, a fan setting
for the ventilation system can be selected. The
twist knob can then be used to configure the heat
settings again.
2. Use the twist knob to select the required setting.
The fan setting that is selected will be shown on the
display panel.
3. To set a different fan setting, touch the A symbol
and use the twist knob to select the required setting.
The fan setting that is selected will be shown on the
display panel.
Switching off the ventilation system
If you want to switch off the appliance, touch the
# symbol. If you only want to switch off the ventilation
system, proceed as follows:
1. Touch the A symbol.
2. Use the rotary knob to select the required fan
setting ‹ .
3. Touch the A symbol to switch to the setting area for
the hob.
Note: The run-on will start once the appliance has been
switched off (depending on the basic settings selected).
Intensive setting
Activate intensive mode if strong odours or large
amounts of steam are produced. In this mode, the
ventilation system briefly operates at maximum power. It
automatically switches back to a low setting after a
short time.
Switching on
1. Touch the A symbol.
2. Turn the rotary knob until ˜ appears.
˜ will be shown on the display panel. The line below the
˜ symbol will flash.Intensive mode is now activated.
Note: After eight minutes, the appliance automatically
switches back to fan setting Š.
Switching off
1. Touch the A symbol.
2. Use the twist knob to select fan setting ‹.
This sets the fan setting for the ventilation system
to ‹.
Automatic start
Depending on the basic settings selected, the following
options will be available once you have selected the fan
setting for a cooking zone:
■ The ventilation system will not start.
■ The ventilation system will start at the fan setting
selected by the sensor.
■ The ventilation will start at a specified fan setting.
Select the option you want to use in the basic settings.
The basic settings also offer the option to adjust the
sensitivity of the sensor. ~ "Basic settings"
on page 29