Operation Manual

Operating the appliance en
11
Operation without the twist knob
The hob can also be operated without the twist knob:
1. Switch on the hob using the main switch.
2. Within the next 5 seconds, simultaneously touch the
œ and . symbols. An audible signal sounds.
3. Touch the . symbol repeatedly until the indicator for
the desired hotplate lights up.
4. Then set the desired heat setting using the œ or x
symbols.
The hotplate is activated.
Notes
■ The timer function cannot be activated without the
twist knob.
■ The twist knob can be placed back on the twistpad
at any time.
1Operating the appliance
Operating the appliance This chapter explains how to set a hotplate. The table
shows heat settings and cooking times for various
meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the # symbol. The display above
the main switch lights up. The hob is ready to use.
To switch off: Touch the # symbol until the display
above the main switch goes out. All hotplates are
switched off. The residual heat indicator remains lit until
the hotplates have cooled down sufficiently.
Notes
■ The hob switches off automatically if all hotplates
have been switched off for more than 15 seconds.
■ The selected settings are stored for four seconds
after the hob has been switched off. If the hob is
switched on again within this time, the previous
settings are applied.
Setting a hotplate
Set the required heat setting using the twist knob.
Heat setting 1 = lowest setting.
Heat setting 9 = highest setting.
Every heat setting has an intermediate setting. This is
marked with a dot.
Selecting a hotplate and heat setting
The hob must be switched on.
1. Select the hotplate. To do this, touch the twist knob
in the appropriate area for the required hotplate.
2. Within the next 10 seconds, turn the twist knob until
the required heat setting appears in the heat setting
display.
The heat setting is set.
 