The user instructions TRX_A21_KIOTO
Matters needing attention ·This instruction manual to guide you the function of the use of mobile phones. ·The company follows the strategy of sustainable development, thus keeping the product function, interface and shape changes without informing the user rights ·Please follow the normal steps to shut down, boot mode or are charging, please don't take the battery discharge, to prevent data loss caused by poor results.
might damage the casing. , such as liquid crystal display parts belong to fragile easy cut parts, note, please do not let the phone hit or strong extrusion. Do not use mobile phones and sharp objects placed together, avoid scratch or mobile phone screen.
·After the battery scrap, not as an ordinary city garbage disposal. The correct processing methods to consult the local regulations regarding the handling of waste electronic products 。 The use of original accessories ·The charger: connect the ac charger and product logo in the same specified power supply. To ensure the wire position correctly, will not be damaged or pressure. To avoid the risk of electric shock, please before cleaning this device, unplug it from the power source.
Take the battery: Hand grip on the fuselage side; Another hand upward pull (or pull, there are only shake handshandle) battery 。 Note: replace or take down the battery must be shut down before! Battery charging: insert the charging cable is corresponding to one end of the phone and mobile phone in the I/O interface; The other end of the charging cable, connected to the travel charger, and insert the plug into the power socket, can give mobile phone battery.
Remind: insert two card, answer a phone can't satisfy the two CARDS at the same time, when a card is in the conversation, when somebody call another card, the other party can hear "you dial the user temporarily unable to connect" voice prompt, such as the case has nothing to do with operator network status. Single only because mobile phones for single chip design, can significantly improve standby time, reducing power consumption.
of WLAN, mobile phone will be automatically connected to the WLAN network connection available before. Bluetooth: this function is a close range wireless communication technology, information can be exchanged at close range, if the device between obstacles, effective distance may be shortened. Select the bluetooth, start the bluetooth wireless and scan.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
BODY-WORN OPERATION: This device was tested for typical body-worn operations with the back of the phone kept 1.5cm from the body. To comply with FCC RF exposure requirements, a minimum separation distance of 1.5cm must be maintained between the user's body and the back of the phone, including the antenna, whether extended or retracted. Third-party belt-clips, holsters and similar accessories containing metallic components shall not be used. Body-worn accessories that cannot maintain 1.
