Owner's manual

________________________________________________________________________________________
Document No. DOC-IPC-003,
User Manual iPC-Series & nPC300, Rev B Rel. 12-2013 Page 19 of 24
Video and the Serial connections have jack screws in the connectors that can be utilized to secure
your cable end to the unit. Ethernet connections have a plastic tab that prevents the connection from falling
out.
See the connecting power section for details on securing the power connections. In addition to the
USB and HDMI Brackets there is an additional cable management bracket at the bottom of the units (N/A on
iPC1200 or nPC300) that can be utilized to strain relief cables. This is a flat bracket attached by 2 screws
which can be utilized to hold down cables or provides an attachment point for a cable tie to be used for
securing cables. Care should be taken to provide an adequate radius for any cable being utilized. Too tight a
radius can damage the conductors. When tightening this securing bar care should be taken not to over crush
cables; this can damage conductors.
Cable Securing Bar Installed
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT
UNLESS THE POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN
TO BE NON-HAZARDOUS USB AND HDMI CONNECTIONS MUST BE
SECURED WITH INCLUDED RETENTION BRACKETS – SEE INSTALLATION
INSTRUCTIONS
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT
WHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREE
OF IGNITABLE CONCENTRATIONS.
NOTE: TO PREVENT INADVERTENT DISCONNECTION OF VIDEO AND/OR
SERIAL TOUCHSCREEN CABLES ASSURE THAT THE THUBSCREWS ARE
SUFFICIENTLY TIGHTENED.
NOTE: WHEN USING USB OR HDMI CONNECTIONS THE USE OF THE
RETENTION BRACKETS IS REQUIRED FOR HAZARDOUS LOCATIONS AND
HIGHLY RECOMMENDED FOR NONHARDAOUS LOCATIONS.