Stainless Steel Dispensers User Manual
Stainless Steel Dispensers Single Double Triple Quadruple Quintuple Model SS6L-1 SS6L-2 SS6L-3 SS6L-4 SS6L-5 Part # 10961 Single Drop In 10962 Double Drop In 10963 Triple Drop In 10964 Quadruple Drop In 10965 Quintuple Drop In Model SS6L-1DI SS6L-2DI SS6L-3DI SS6L-4DI SS6L-5DI Part # 10966 10967 10968 10969 10970 Complete Pump 10185 Dome 7299 Pump Housing 10196 Dome Clip 7868 Hose 7368 Connector 9472 Brush 7615 Designed for use with standard 1½ gallon pouched condiments and toppings.
Safety All components must be cleaned before first use. According to food and safety regulations, most foods must be stored and/or served at certain temperatures or they could become hazardous. Check with local food and safety regulators for specific guidelines. Be aware of the product you are serving and the temperature the product is required to maintain. IMPORTANT Clean, rinse, sanitize, and dry parts at a minimum of every 24 hours. Always comply with local sanitization requirements.
Assembly 1 2 3 4 4 Mount the nozzle onto the end of the pump housing. Bend the outer portion of the nozzle inside out. Insert into opening. Tab of nozzle faces towards housing. Flip the outer portion of the nozzle over the end of tube. Insert dome into the pump housing. Ensure the flaps slide into place. Press the entire dome firmly, including the top portion. Insert the dome clip over the dome and pump housing. Ensure that the tab on bottom of the dome slides into the opening in the dome clip.
6 7 Attach connector to hose Fit the bottom holes on hose over the pegs on the connector. Piercing end of the connector must face away from pump housing. Connect pump to pouch Put new pouch on countertop with fitment facing up. Place piercing end of connector in center of the fitment. Push firmly until pump snaps into place. Insert pouch and pump into the dispenser shroud. Hold end of pouch up while guiding the pump into the slots inside the front of dispenser.
8 9 Insert the lid Hold the lever up while inserting lid tabs into slots in back of dispenser shroud. Prime pump Press lever several times until food is visible in discharge tube. Drop-In Dispensers Add Corner Guards: Hook first tab into slot. Push firmly on second tab to Snap into place.
Setting the Portion Remove locking washer 1 Use a flathead screwdriver to pry off the locking washer from the pin at the end of the link arms. Keep locking washer for step 4. Remove pin 2 3 Slide the pin out from the pair of link arms and portion holes. Select portion setting Not applicable on this dispenser. 1 oz 1/2 oz 2 mL 4 Align holes on link arms with hole for desired portion setting. Slide pin through all. Secure pin with locking washer.
Tips & Troubleshooting Prevent leaks: Ensure that dome is pushed fully into pump housing. Ensure that you hear a CLICK when attaching pump to pouch. Pro Tip: Clean water may be used as lubrication when fitting hose onto pegs. Optimize pouch evacuation: Ensure ramp is in place. Available In the USA through: Asept International Inc. 900 Oakmont Ln, Suite 207, Westmont IL 60559, USA +1 (630) 441-5656 info.us@asept.com Asept International AB Traktorvägen 17, SE-226 60 Lund, Sweden +46 46 329 700 info@asept.