Instruction Manual

1. On/Off Switch – This gives the user the ability to turn the appliance On or Off. Note: this does NOT turn
power off to every internal component.
2. Adjustable Legs – Gives the installer the ability to level the press as needed.
3. Sandwich Press Cavity – The cavity is constructed with stainless steel and a nonstick coating.
4. Heating Platens – These can be grooved or flat heating surfaces. The upper platen is able to float to allow
for even surface contact for varying height of food items.
5. Steam Vent - Allows steam to escape the cavity.
6. Specification Plate – This plate shows the ratings for this device along with, model & serial number, and
NEMCO contact information.
7. USB Port – This port is used to load menu files with an approved USB flash drive.
8. Cover, Steam Vent Cleanout – This cover is removable with standard tools to allow for cleaning inside the
steam vent.
9. Panels, Side Access – These panels are located on the RH and LH side of the lower enclosure to give
service technicians access.
10. Microwave Choke Assembly – This assembly contains the lower heating platen and is removable to allow
access to the lower enclosure. Note: If this is removed, then its location will need to be set correctly to
ensure microwave leakage is within safe ranges.
11. Panel, rear Access – This panel gives a service technician access to the rear enclosure.
12. Power Cord – Is located at the back of the lower enclosure.
13. Cooling Fans – These are located behind the top enclosure filter and need to be kept clear of obstructions
to ensure the magnetrons stay cool.
14. Release, Upper Heater Platen – This is turned a quarter turn to drop the upper heater platen down for
cleaning and service.