Model Series: 8010, 8018, 8027, 8036, 8045W, 8045N, & 8075 Includes Chrome, or GripsIt, Flat or Slant, and 120 Volt or 220 Volt Units OPERATING AND MAINTENANCE INSTRUCTIONS AND SERVICE PARTS LIST INTRODUCTION 1. Please read instructions before using 2. Clean machine thoroughly before and after all uses using cleaning instructions below 3. This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL SAFETY INSTRUCTIONS 1.
OPERATION 1. During slow sales periods, turn rear rollers on low heat and fill rollers with product. Keep front rollers on medium and serve product from there. Shift product from the rear to the front and reload. 2. During busy periods, set rear control to medium and front control to high. Serve from the front rollers first. 3. During very busy periods, set all thermostats on high. Fill all of the rollers with product. At this temperature, product should be sold within 15 minutes.
IF ROLLERS WON’T HEAT Check power source to be sure machine is plugged into the proper voltage outlet (120 or 220 volt) and the receptacle is working. If properly connected and still no heat call NEMCO customer service at 1-800-782-6761 IF PILOT LIGHTS DON’T WORK 1. Disconnect the unit from the power source, open the control panel by removing both end covers and look for loose connections. 2. If unit is properly wired, replace the pilot light. 3. Replace end covers and reconnect the machine.
NEMCO FOOD EQUIPMENT Phone: (419) 542-7751 301 Meuse Argonne, Hicksville, OH 43526 Fax: (419) 542-6690 Toll free: 1-800-782-6761 www.nemcofoodequip.