Instruction Manual

IF ROLLERS WON’T HEAT

Check power source to be sure machine is plugged into the proper voltage outlet (120 or 220 volt) and the

receptacle is working. If properly connected and still no heat call NEMCO customer service

at 1-800-782-6761

IF PILOT LIGHTS DON’T WORK

1. Disconnect the unit from the power source, open the control panel by removing both end covers and look

for loose connections.

2. If unit is properly wired, replace the pilot light.

3. Replace end covers and reconnect the machine.

HOW TO REPLACE THE MOTOR

1. Disconnect the unit from the power source.

2. Remove the end cover from the motor side. On single motor units (one on/off switch) the motor is on the

left while facing the operator side on the unit. On dual motor machines there is a motor on each side. The

motor on the left drives the front rollers and the motor on the right drives the rear rollers.

3. Disconnect the chain from the motor sprocket and then remove the motor sprocket from the motor.

4. Turn the unit over and remove the bottom cover. Disconnect the motor wires and remove the motor

screws. Remove the motor and replace with a new motor.

5. To reassemble, reverse the above procedure BEFORE RECONNECTING TO THE POWER SOURCE.

HOW TO REPLACE THE THERMOSTAT

1. Disconnect the unit from the power source.

2. Remove the knobs and the drip pan.

3. Turn the unit over and remove the bottom cover.

4. Loosen nuts or screws that hold the thermostat to the unit. Disconnect wires from the thermostat,

replace with new thermostat and reconnect wires as per the diagram.

5. To reassemble, reverse the above procedure BEFORE RECONNECTING TO THE POWER SOURCE.

HOW TO REPLACE THE ROLLERS

1. Disconnect the unit from the power source.

2. Remove the end covers from each side of the unit.

3. Remove the wires and the clips from both ends of the element and remove the element.

4. Remove motor sprocket with 3/32 Allen wrench.

5. Remove the chain guard by removing the two screws.

6. Disconnect chain from motor and rollers.

7. Remove rollers and replace with new rollers

8. To reassemble, reverse the above procedure

NOTE: WARRANTY DOES NOT COVER DAMAGE TO THE ROLLERS OR

ROLLER COATING. IT IS NEMCO'S SOLE DISCRETION TO DETERMINE IF

A ROLLER OR ROLLER COATING CLAIM IS WARRANTED.