User guide

®
Connect Pump
Connect the Nemoid™ foot pump to the airbeam valves through
the access zippers. There will be an audible click when the pump is
connected properly. Pump can be attached inside in rainy weather.
Stake Corners
Secure the corner anchors by pounding the stakes into the ground
with a rock or hard object. If the ground is too hard, trap the stakes
under a rock or another heavy object.
Inflate Airbeams
To use the Nemoid™ foot pump, make sure the Dump-Check™ Valve
is open. Step on the pump body repeatedly until it becomes difficult
to compress. To deflate, attach Deflator Cap to airbeam valves.
Tension
Proper tension in your tent shell ensures maximum water shedding
and wind resistance. Once the airbeams are inflated, pull firmly on
the adjustable corner anchors. Add guy-lines for additional strength.
Locate Valves
Remember to leave no trace. Before leaving your campsite, take a thorough look
around making sure you have not left anything behind, out of place, or damaged.
To contact NEMO Customer Service
Email: [e-mail]
Phone: [phone]
MORPHO
™
1P
INSTRUCTIONS FOR SETUP
Locate black inflation valve access zippers near base of tent. The
airbeam valves will be directly inside the tent, behind the access
zippers. If attached, remove Deflator Cap by pressing button.
1
2
3
4
5
©2011 NEMO Equipment, Inc.