Quick Start USER ECOROX Models: Features & GDI-EGRX600--610 ECOROX Control Buttons LED Status Indicators: POWER BATTERY Diagram 1 Contol Buttons & LED’s Diagram 2
Quick Start USER ON/OFF Bluetooth TRACK SPEAKER How to pair VOLUME your SmartphoneSELECTION PLAY PAUSE ANSWER BATTERY INDICATOR with your ECOROX ON/OFF Bluetooth STEP 1. Find & enable Bluetooth on your Smartphone/ Smartdevice Green LED STEP 2. PRESS button turns ON & once on ECOROX to after a few initiate Bluetooth seconds delay the unit beeps to BLUE LED will blink rapidly indicating ready indicate power initiated and set to pair. ON STEP 3.
Quick Start USER selection & select “ECOXGEAR” to pair with ECOROX STEP 4. Select & play your music! reached on the ECOROX speakers & talk over the built-in Microphone on the front of the unit time remains USB & AUX-IN CONNECTIONS RUBBER CAP, USB POWER & AUX-IN CONNECTIONS Pull tab on the rubber cap to open the back panel compartment for access to AUX-IN & USB CHARGING connections AUX-IN can be used as an optional connection to play an audio device using a 3.5mm audio cable connection.
Quick Start USER USB CONNECTION & CHARGING Charge the built-in rechargeable battery via USB cord (included) connected to your computer OR via a USB-to-AC power adapter. When connected to a power source via the USB connection on the back panel, the Battery LED on the front panel (refer to Diagram 2.) will indicate the power status. IF not connected to the charging cable, the LED will NOT indicate the power status. RED LED indicates charging is in progress.
Quick Start USER Diagram 4 TIP: Bluetooth PAIRING once paired, should you wish to connect to an alternate device, open the Bluetooth Section within the device currently connected to the ECOXBT and remove the Bluetooth connection.
Quick Start USER FRONT PANEL SIDE PANEL BOTTOM PANEL & MOUNT SPECIFICATIONS Output Power: RMS 6W (3 Watt x2 speakers /4 ohms) S/N Ratio: 88db +/- 3dB Frequency Range: 125Hz-18,000Hz Unit Size: Power Source: Playtime: Lithium Ion 3.
Quick Start USER FCC Compliance Statement & Warning: This device has been tested & found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The device generates, uses & can radiate radio frequency energy & if not installed & used in accordance with instructions may cause harmful interference to radio communications.
Quick Start USER ATTENTION: AC adaptor is a device forming a part of the main plug therefore the AC adaptor can always be readily disconnected from AC socket-outlet. CARE, MAINTENANCE & PRECAUTIONS 1. The unit is waterproof when the RUBBER CAP is properly closed. 2. Close the CAP properly before use, see ‘diagram 4’ for reference. If the unit is placed in water without the cap properly closed, water may enter into the unit and void your warranty. 3. Dry unit completely before opening the cap.
Quick Start USER other than the one for which they were manufactured. Please refer to the above care and maintenance instructions for suggested care details. The warranty is valid only for the original owner who purchases the unit from an authorized dealer. Transfers do not qualify for warranty protection. Grace Digital reserves the right to replace any out-of-stock or discontinued product with a comparable product. Discontinued products may not be available for warranty replacement.
Quick Start USER FCC STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Quick Start USER FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
