Instruction Manual

Product Introduction
The PIR is a passive infrared detector or body sensor with a temperature probe, the sensor doesn’t
emit any energy but only passively receive and detect infrared radiation from outside. Under room
temperature, all items have radiation. Human beings are warm-blooded animal with stable infrared
radiation, are most easily to be detected. That’s why we also call it body sensor. PIR send
messages via Z-wave network to the Z-wave main controller. In the Z-wave network
communications, PIR can be connected to any Z-wave main controller, Different countries or
areas, the radio frequency is different of the Z-wave network. In the communication between the
PIR and Z-wave main controller, PIR can only send messages, not be able to receive messages.
When the PIR is triggered, PIR will send message to the Z-wave main controller, and associate
devices to work through the Z-wave main controller. The PIR is battery powered, is small and can
be installed easily.
Technical Parameters
 Motion detection
 Measure the light sensitivity
 Detection temperature
 Compatible with 300 series and 500 series
 Easy installation on wall or any surface
 Range: up to 50m outdoor
 up to 30m indoor
 Power supply: CR123A x 1
 Standby current: 16uA
 Battery life: 1 years
 Radio Protocol: Z-wave
 Radio Frequency: 868.4MHz EU; 908.4MHz US
 Detection range: 7 meters
 Viewing angle: 110 degree
 Temperature range
：
0-99℃
 Operation temper: 0-40℃
 Storage temperature: 0-60℃
 Size (D x W x H): 45mm x 45mm x 48mm
Technical Information
 Use passive IR sensor to detect what is moving.
 When the PIR is triggered, LED light flashes in the detection area.
 Easily install with screws or sticker on the wall or the table.
 When there are people or animal that is moving in the PIR detection area, PIR
will send alarm messages to the Z-wave main controller.
 Compatible with any Z-wave main controller.