User's Manual
Table Of Contents
- Motion 5In1 User Manual
- Z-Wave™ Network Inclusion/Exclusion/Reset
- Association
- Z-Wave™ Message Report
- Command Class Configuration
- 1)Led Indicator Enable
- 2)Motion Enable
- 3)Motion Alarm Once Enable
- 4)Luminance Associated Enable
- 5)Binary Sensor Report Enable
- 6)Motion Sensitivity
- 7)Temperature Offset Value
- 8)Humidity Offset Value
- 9)Temperature D-Value Setting
- 10)Humidity D-Value Setting
- 11)Luminance D-Value Setting
- 12)Basic Set Level
- 13)Motion Blind Time
- 14)Basic Set Off Delay Time
- 15)Motion Clear Time
- 16)Luminance Threshold for Associated
- 17)Sensor Measuring Interval
- 18)Light Intensity Offset Calibration
- Wakeup Command Class
- Battery Command Class
- Command Class Basic
- SmartStart
- Led Action Indicator
- All Supports Command Class
10
SmartStart
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code
present on the product with a controller providing SmartStart inclusion. No further action is
required and the SmartStart product will be added automatically within 10 minutes of being
switched on in the network vicinity.
This device supports SmartStart function. QR code printed by laser can be found on surface of
product and the outside of packing box. And the full DSK code is printed can be found on the
packing box.
The device will enter SmartStart if the device is not included in network after power up. And if
device is not included successfully during 10 second, it will enter sleep mode. And then
2
nd
SmartStart time delay approximately 16s
3
rd
SmartStart time delay approximately 32s
4
th
SmartStart time delay approximately 64s
5
th
SmartStart time delay approximately 128s
6
th
SmartStart time delay approximately 256s
7
th
SmartStart time delay approximately 512s
Afterwards, the Smartstart mode will be auto running with 512 second interval until device is
included successfully or battery run down.
Led Action Indicator
Led Color
Action
Description
Red
Light On 1s When Power On
Not Add in Z-Wave Network
Fast Blinks
Cover is Removed
Pink
Light On 2s
Press And Hold Button 10s, Off at 12
th
Second
Blink One Time
Motion is Detected
Green
Light On 1s When Power On
Add in Z-Wave in Network Already
White
Light On 2s
Press And Hold Button 5s, Off at 7
th
Second
Cyan
Blink One Time
Cover is Closed
Blue
Blink with 1s Interval
Add to Z-Wave Network
Blink with 500ms Interval
Remove from Z-Wave Network
Yellow
Blink with 500ms Interval
OTA is Running
Light On Always
Button Pressed and Held Time Large Than 12s.