User's Manual

6
Command Class Configuration
The device supports the controller to configure parameters of the device through Configuration
Command Class, and the device has 18 parameters available for users to set according to their
different needs:
1) Led Indicator Enable
This parameter is configured the Led light on disable or enable.
‘1’ – Enable Led Blink when device detects a motion event.
‘0’ – Disable led blink. This configuration is not affect inclusion, exclusion and reset.
Parameter Number
Size (Byte)
Available Settings
Default value
1
1
0, 1
1
2) Motion Enable
This parameter is configured the motion detected if enable ornot.
‘0’ – Motion detected disable.
‘1’ – Motion detected enable.
Parameter Number
Size (Byte)
Available Settings
Default value
2
1
0 , 1
1
3) Motion Alarm Once Enable
This Parameter is configured the motion detected event report one time before motion event cleared.
‘0’ – Motion event alarm will be reported when motion event is detected every time.
‘1’ – Motion event alarm report only once before motion event cleared.
Parameter Number
Size (Byte)
Available Settings
Default value
3
1
0 , 1
1
4) Luminance Associated Enable
‘1’ – Enable current light intensity to associate the motion event, if there has a motion event
detected and the current light intensity is less than the settings in Configuration No.16, the device
will send a BASIC_SET to nodes associated in Group 2. And if the current light intensity is larger than
the settings in Configuration No. 16, the device will not send BASIC_SET to nodes associated in
Group 2.
‘0’ – Light intensity is not associated with motion event.
Parameter Number
Size (Byte)
Available Settings
Default value
4
1
0, 1
0
5)
Binary Sensor Report Enable
‘1’ – Enable sensor binary report when device detects a motion event.
‘0’ – Disable sensor binary report when device detects a motion event.
Parameter Number
Size (Byte)
Available Settings
Default value
5
1
0, 1
0