User Manual

Appendix A: Using Your NeoPoint Phone as a Modem
NeoPoint 1600 User’s Guide 103
Using Your NeoPoint to Receive/Send a Data File
The following section provides information required for setting up your data transfer
program and use your NeoPoint phone as a modem to send/receive a data file. Refer
to your data transfer program documentation for specific setup and data transfer
instructions.
Verify the following modem properties when setting up your data transfer program.
• Baud Rate: 19200 bps (default)
• Data Bits: 8
• Stop Bits: 1
• Parity: None
• Flow Control: Hardware (RTS/CTS)
Receiving a Data File
On Your NeoPoint Phone:
1. Ensure that your NeoPoint phone is connected to your PC and is powered ON.
2. Once the Main screen is displayed on your NeoPoint phone, press and release
the POWER ON/OFF key to go to Quick Mode.
3. Using the Navigator key, scroll to Incoming.
4. Set Incoming mode to Data In.
NOTE:Once you have set your NeoPoint phone Incoming Mode to
Data In, you cannot receive regular voice calls until you change
Incoming Mode back to Voice.
Refer to your data transfer program for instructions on receiving a data file.
On Your PC/Laptop:
NOTE:Ensure your baud rate/bits per seconds is set to 19200 for
receiving data.
1. Type one of the following AT commands:
• ats0=x (where x = 1, 2, etc.) to automatically answer the incoming call
• ata when receiving a ring message to manually answer the incoming call
2. File transfer can begin when the message CONNECT is displayed.