User Manual

104 NeoPoint 1600 User’s Guide
A
Sending a Data File
NOTE:Your NeoPoint does not require that you change to Incoming
mode - ensure that Incoming Mode is set to Voice.
Use your modem program to initiate data call.
For example - to manually make a data call type atd followed by the phone number,
e.g., atd2225558888.
When a call is established, a message stating CONNECT is displayed on the terminal.
File transferring can now begin.
Select the name of data file where it is stored and the protocol that you want to send
the file.
AT Commands
Transferring data files requires you to use AT commands. The following tables list
some of the more common AT Commands, S-Registers, and Basic Action
Commands. For more AT commands, refer to your data transfer program
documentation.
Table 1: Basic AT Parameters
Command Description
E0 Do not echo in command state or on-line command
state.
E1 (default) Echo in command state or on-line command state.
Q0 (default) Return result codes.
Q1 Do not return result codes.
V0 Display result codes as numbers.
V1 (default) Display result codes as words.
Z0 (default) Reset to default configuration.