User Manual

required the installation should be done in the fabrication shop prior to sheet
installation.
The EZI/STD Charging Unit – Individual package consists of the transmitter,
power cord and transformer. PMA-compliant charging rings are available
separately in packs of three: one ring each of micro USB, Apple 30-pin and
Apple Lightning® PMA compatible receivers.
The transmitter has a micro USB port for updating the firmware if necessary.
A. PREPLANNING
A.1. Box Contents
The box will come with the transmitter and the power supply (not pictured
here).
A.3. Placement
There are several considerations regarding proper placement of the transmitter:
• Avoid putting in proximity to locations where the device being charged
may get wet, exposed to excessive heat or any other conditions which
may damage the device being charged. !
• Do not install next to heat sources (such as stoves) or where heat sources
are commonly used (toasters, hot plates, etc.). !
• Stay away from edges where charging devices can be easily knocked off
the surface. !
Work with the customer to determine convenient locations. Page 1 of 4 !
EZI/STD CHARGING UNIT – INSTALLATION
The transmitter requires a rectangular space of 82 mm x!
92 mm (3.23"x 3.60") below the surface counter. Allow an extra 25 mm (1")
distance to any support structure. No metal should be between the transmitter
and the surface. The transmitter also requires 36 mm (1
7
/16") vertical clearance
measured from the top surface (24 mm (0.94") from bottom surface). Avoid
placement above heat- or moisture-generating appliances such as dishwashers,