User's Manual

2
Regulatory notices
Federal Communications Commission notice
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as
in compliance with the FCC RF exposure guidelines. SAR information on this model is on file with the FCC and can
be found under the Display Grant section of http://www.fcc.gov/oet/ea/fccid.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by HP may void the user's authority to operate the equipment.
Cables
To maintain compliance with FCC Rules and Regulations, connections to this device must be made with shielded
cables having metallic RFI/EMI connector hoods.
Declaration of Conformity for products marked with the FCC logo (United
States only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 2 conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
For further information, contact:
Manager of Corporate Product Regulations
Hewlett-Packard Company
3000 Hanover Street
Palo Alto, CA 94304
[phone]
To identify your product, refer to the part, series, or model number located on the product.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Australia and New Zealand notices
This equipment incorporates a radio transmitting and receiving device. In normal use, a separation distance of cm
ensures that radio frequency exposure levels comply with the Australian and New Zealand Standards.
WARNING: Exposure to Radio Frequency Radiation The radiated output power of this device is below the
FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the
potential for human contact is minimized during normal operation. When operating the device in close
proximity to your body, use a non-metal storage accessory (e.g., holster) to position the device a minimum
distance of cm from the body.
CAUTION: When using IEEE 802.11a wireless LAN, this product is restricted to indoor use, due to its
operation in the 5.15- to 5.25-GHz frequency range. The FCC requires this product to be used indoors for
the frequency range of 5.15 GHz to 5.25 GHz to reduce the potential for harmful interference to co-channel
mobile satellite systems. High-power radar is allocated as the primary user of the 5.25- to 5.35-GHz and
5.65- to 5.85-GHz bands. These radar stations can cause interference with and/or damage to this device.
787557-B21.fm Page 2 Friday, June 27, 2014 11:41 AM