User Manual

9999counts Handheld multimeter
9/15
2-3-5.DC/AC 10A Current (DC/ACA)
The maximum measured pressure drop：600mV；
Overload protection：6A/10A: 10A:10A/250V Speed Glass Fuse;
The specific operation is as follows: The figure on the right shows
AC and DC 6A/10A
1. Insert the black meter pen into the "COM" jack and the red meter pen
into the "V/Ω/Hz" jack; the default value is DC, triggering the
"RANG" button to switch between automatic/manual 10A currents；
2. Turn the range switch to the corresponding DC/ACA position. The default value is AUTO DC10A. Then connect the meter to the circuit under test.
The measured current value and the current polarity of the red test point will be displayed on the screen at the same time. Trigger "SELECT" key to
select AC current AC10A；
Note：
1) The instrument series connection to the circuit pending to test before the circuit should be the first power off;
2）The maximum input current is 10A (depending on the insertion position of the red meter pens), not more than 10 seconds, excessive current will
cause the circuit to heat, or even damage the instrument;
3）When the test leads are plugged into the current input terminals, do not connect the test leads to any circuit in parallel or it will damages the fuses
and the instrument.
5）After the completion of all the measurement operation, you should first turn off the power and then disconnect the test leads and the measured
circuit connection, especially to high current measurement.
6）It is forbidden to input more than 36V DC, 25V AC voltage between the current jack and the "COM" jack.
Accuracy
Range
9999counts
Resolution
10A
±（2.0%+30）
0.01A