User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Setting Up the R900 Belt Clip Receiver
N_SIGHT R900 User’s Manual for the Neptune Handheld System 5-13
Selecting the R900 Belt Clip Receiver Reading Mode
To choose the reading mode, complete the following steps.
1 On the Nomad, click .
2Click – U
tilities.
3Click
– R900 Belt Clip Receiver Status.
The R900 Belt Clip Receiver Status screen appears.
4
Tap the drop-down selection list for RF Mode and you can choose
the reading
mode. See the modes listed above.
Using the R900 Belt Clip Receiver RF Test Mode
RF Test Mode allows the R900 BCR to go into a continuous receive
mode and listens for any and all R900 transmissions.
From the Login Screen
To access RF Test Mode from the
Login screen, complete the
following steps.
1 On the Nomad, click
.
2Click – U
tilities.
3Click – RF Test.
The RF Test Mode screen
appears as illustrated in Figure
5.4.
Figure 5.4 R900 Belt Clip Receiver RF Mode Screen
5
8
5
7
Pilot Release