User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Setting Up the R900 Belt Clip Receiver
N_SIGHT R900 User’s Manual for the Neptune Handheld System 5-15
Updating R900 Belt Clip Receiver Firmware
When there is an update to the R900 BCR firmware, it is available from
Neptune through the web updates in the N_SIGHT R900 software, or it
can be obtained from Ne
ptune Customer Support through email or direct
upload to an FTP site.
With either choice for receiving the firmware update; the firmware
is
updated in the N_SIGHT R900 database and then sent to the R900 BCR
through the USB transfer cable
or saved to the SD card and installed on
the R900 BCR.
To update the R900 BCR firmware, complete the following steps.
1 Connect the R900 BCR to the PC and place in Ma
ss Storage M
ode.
2 In the N_SIGHT R900 host software, select Utilities.
3 Select the Beltclip Fi
rmware tab.
Figure 5.6 Tab within N_SIGHT R900 Utilities
You cannot update multiple R900 BCRs at once; they must be updated individually.
To update the R900 BCR firmware update with the USB cable, the R900 BCR must
first be connected to the PC and be in Mass Storage Mode. To update through the SD
Card, the Firmware Update File can be transferred to the SD card by using an SD Card
Reader
Pilot Release