User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Gathering Route Data
N_SIGHT R900 User’s Manual for the Neptune Handheld System 6-3
Manually Collecting Meter Readings
When using the CE5320 to collect meter readings, typically you need to
enter only the reading for each meter. However, sometimes you may
need to also enter a trouble code or comment concerning conditions at
the account. Additionally, you may “skip” an account by inserting a
“skip code” and indicating why you skipped the account. The
procedures in this topic give you the information you need to manually
collect or skip readings:
• “Entering a Reading,” which follows
• "Entering a Skip Code" on page 5
• "Entering Comment Codes" on page 7
• "Adding Free-Form Notes" on page 9
Entering a Reading
Follow this procedure to enter a meter reading in the handheld.
1 If you have not already done so, first log into N_SIGHT R900 on
the handheld, so that a reading-entry screen is appears in the dis-
play. See Fig
ure 6.1 on Page 6-2.
For help with this task, refer to “Logging Into N_SIGHT R900 on
the CE5320,” on page 3-26 or “Logging Into N_SIGHT R900 on
the Nomad,” on page 4-31.
If this is the first time that you have accessed a route, the reading-entry
screen of the first meter in the route appears in the display. If the read
direction is set for
, “Left to Right,” then after the reading for the first
meter is taken the screen advances to the second meter in the route. By
clicking this icon, you can change the read direction to , “Right to Left.”
The read direction toggles between these two read directions.
Pilot Release