User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Gathering Route Data
6-4 N_SIGHT R900 User’s Manual for the Neptune Handheld System
2 Using the number keys, enter the reading in the space provided.
Figure 6.2 N_SIGHT R900 Reading Entry Field
3 Touch or press .
The N_SIGHT R900 software displays the next meter in the route,
according to the route direction or . Touching this ic
on and
temporarily change the direction for the route. However, to change
it for future uses
, refer to the procedure for “Changing the Route
Direction, Forward or Reverse,” on page 6-14.
4 Continue entering readings for each meter until you have com-
pleted all routes assi
gned to you.
As you complete each route, a message appears in the display to let
you know that you
have completed the route and are moving to a
new one. Follow the instructions shown in the display to access the
reading-entry screen of the next route.
Reading entry field
The number of hyphens in the reading entry field indicate the number of
reading digits required.
Pilot Release