User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Gathering Route Data
N_SIGHT R900 User’s Manual for the Neptune Handheld System 6-31
4 Correct any of the following information.
• Using the letter and number keys, correct the meter number in
the ID EXP field, if applicable.
•In t
he MTR TYPE fiel
d, touch the arrow,
and select the
type of meter just found, if applicable.
• Touch the DIALS field, and enter the number of dials that the
new me
ter uses, if applicable.
• Touch the DECIMALS field, and enter the number of deci-
mals
that the meter uses, if applicable.
• Touch the notes field and type any notes, if applicable.
5 T
ouch to accept the changes you made to the meter.
The changes made to the meter is reflected in the current route with
which you are work
ing.
Finding and Displaying Reading-Entry Screens
The procedures in this section explain how to move within a single
route, change routes, search for specific meters, and use the bookmark
feature. The following tasks are explained in this section.
• “Moving Through Reading Entry Screens,” on page 6-32
• “Moving Around Routes,” on page 6-35
You will need to print these changes in a standard report. Usually, when the
information is transferred from N_SIGHT R900 to the billing system, this
information is not updated by the billing system.
Pilot Release