User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
8-6 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Verifying the Handheld Recognizes the Mouse
If the handheld does not recognize the mouse, complete the following
steps.
1 Exit the NHPSProSys software.
See “Exiting the Software,” on
page 7-1.
2 Verify that the mouse and/or receiver are connected to the handheld
device.
3 Run Instal
lEngine_HH.exe and wait for
it to finish.
4 Restart the handheld using the Software Reset locate
d in Options
in the CE window.
5 When the handheld is running, select NHPSProSys.exe.
6 Verify that
the program recognizes the mouse or receiver.
Starting Field Programmer
To start the Field Programmer, complete the following steps.
This can take some time for the handheld to check for the mouse. Wait at
least 30 seconds for the handheld to recognize the mouse.
Pilot Release