User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the Field Programmer
8-34 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Using the New ProRead Format
To use the newly created format to program ProRead registers, complete
the following steps.
1 Select the SelectFMT tab
.
2 Complete the steps outlined
in “Selecting a ProRead Format,” on
page 8-31.
3 Refer to “Programming the ProRead,” on page 8-9 to program,
query, or read the ProRead register using the newly created format.
Deleting a Format for ProRead Registers
To delete a user-defined format used for programming ProRead
registers, complete the following steps.
1 Log in to the Field Programmer by completing steps 1 through 3 in
“Selecting ProRead Preferences,” beginning on page 8-29.
2 Select NewFMT.
The New Format screen appears as illustrated in Figure 8.32 on
page 8-32.
3 Touch since the NewFMT screen now defaults to New,
then shift the numbers to compensate.
4 Touch or click to delete the format from the list of avail-
able formats.
A confirmation dialog similar to the following appears asking if
you
are sure you want
to delete this file format.
5 Touch or click Yes to save the format
or No to cancel.
The format is no longer available for selection on the
Field Programmer.
You cannot delete a standard format from the list of available formats.
Pilot Release